Pilot Lights

My furnace pilot light lights, but the safety valve will not open to light the boiler.?

I turned on the boiler to heat the house and heard that it works, but the heat does not turn. I opened the lid of the boiler, turned turn it off, waited 10 seconds, turned it back on, the LED based, but the main burner does not ignite. The pilot ignition bizarre kind of intermittent. It burns well and stay lit. I wonder if there is a problem with the circuit board or a problem of earthing possible here. Someone has similar issues?? The boiler is a unit of Burnham ES2 LP.

The problem is most likely that your thermocouple. It resembles a sharp metal probe tip in the pilot flame. When working properly, it will send a signal to the burner valve adage "The pilot, it is safe to open the tap and give it gas. When covered with carbon, it will not, then take the sandpaper to him or unscrew from the valve (it is connected by a copper pipe about 1 / 8 inch thick). Any any home improvement store has a generic for about $ 10. Hope this helps.

---

---

Account limit of 2000 requests per hour exceeded.